HIKVISION 9 Series

Under disarming mode, it will not receive alarm message when the detector
is trig
gered.
•
When the zone type is set to be 24H Alarm, the indoor staon will receive
alarm messag
e when the detector is triggered no maer it is under arming
mode or disarming mode.
•
When the zone type is set to be Delay Alarm, only under arming mode, the
indoor staon will receive alarm message when the detector is triggered.
Under disarming mode, it will not r
eceive alarm message when the detector
is triggered.
•
Aer
seng enter delay me, if OK is pressed within the enter delay me
aer the alarm, the alarm event will not be uploaded to the management
center; if OK is not pressed within the enter delay me aer the alarm, the
alarm event will be uploaded to the management center.
•
The exit delay is the me between you enable the arming mode and the
arming t
akes eect.
IP Camera Informaon
You can add, delete and modify cameras that can be added to the video intercom
pr
oducts, with two ways of geng stream: direct or URL. By exporng and imporng
the added device informaon, you can edit added devices parameters in batch.
Add Camera
Steps
1.
Click IP Camera Informaon to enter IP camera informaon page.
Figure 3-11 IP Camera Informaon
2.
Click Add t
o pop up the device adding dialog box.
3.
Enter corresponding informaon (device name, IP address, port No., user name,
pass
word, etc.), and click OK.
Video Intercom 9 Series Indoor Staon Conguraon Guide
27