User Manual of 9600/8600/7700/7600 Series NVR
151
Notes: This chapter is applicable for 9600-R series only.
10.1 Configuring Array and Virtual Disk
Purpose:
RAID (redundant array of independent disks) is a storage technology that combines multiple disk drive
components into a logical unit. A RAID setup stores data over multiple hard disk drives to provide enough
redundancy so that data can be recovered if one disk fails. Data is distributed across the drives in one of several
ways called "RAID levels", depending on what level of redundancy and performance is required. The 9600-R is
capable of realizing Redundant Array of Independent Disk, supporting RAID0, RAID1, RAID5 and RAID10.
Before you start:
Please install the HDD(s) properly and it is recommended to use the same enterprise-level HDDs (including model
and capacity) for array creation and configuration so as to maintain reliable and stable running of the disks.
Introduction:
The 9600-R series can store the data (such as record, picture, log information) in the HDD only after you have
created the virtual disk or you have configured network HDD (refer to Chapter 11.2 Managing Network HDD).
Our device provides two ways for creating the virtual disk, including one-touch configuration and manual
configuration. The following flow chart shows the process of creating virtual disk.
Figure 10. 1 RAID Working Flow
10.1.1 One-touch Configuration
Purpose:
To Next Page
Loading...
Need help?
General