and then tap Linked Areas to set the area linked to the target user.
Note
Only the administrator can do such an operation.
If the target user is a administrator, an installer, or a manufacturer,
you can tap the target user on the user list and then tap Edit Keypad
Password to set the keypad password to the target user.
If the target user is an administrator you can tap the target user on
the user list and then tap Edit Duress Password to set the duress
password to the target user.
Note
If under duress, you can enter the duress code on the keyboard to
arm and disarm area(s) and upload a duress alarm.
Note
● Configuration items and user permission will vary according to the user type.
● You can view linked Tags/tags and keyfobs of the user but you do not have permission to
configure them.
Example
Enter an example that illustrates the current task (optional).
What to do next
Enter the tasks the user should do after finishing this task (optional).
Tag Management
After adding Tags/tags to the wireless AX PRO, you can swipe the Tag to arm or disarm all the
detectors added to specific area(s) of the AX PRO, and clear alarms.
Steps
1. Enter the site, tap the AX PRO and then log in to the device (if required) to enter the page.
2. Tap → User Management → Tag to enter the Tag Management page.
3. Tap + to add a Tag.
4. When hearing the voice prompt "Swipe Tag", you should present the Tag on the AX PRO Tag
presenting area.
● When hearing a beep sound, the Tag is recognized.
To Next Page
Loading...
Need help?
General
