AX PRO User Manual
66
the device is disarmed, the indicator will be off.
Note
Only -P model supports this function.
Prompt Fault When Arming
If the device applies EN standard, by default, the function is disabled. In this case, the device will
not prompt faults during the arming procedure.
Note
Only -P model supports this function.
Enable Early Alarm
If you enable the function, when the zone is armed and the zone is triggered, the alarm will be
triggered after the delay time.
Note
The early alarm will be taken effect only after the delayed zone is triggered.
Fault Check
The system determines whether to check the faults listed on the page. The system will only check
the fault that is selected.
Click System → System Options →Fault Check to enter the page.
Detect Network Camera Disconnection
If the option is enabled, when the linked network camera is disconnected, an alarm will be
triggered.
Battery Supervision
To Next Page
Loading...
Need help?
General
