Network Camera User Manual
98
storage or in the network disk.
Steps:
1. Enter the Record Schedule Settings interface: Configuration > Storage >
Schedule Settings > Record Schedule.
Figure 11-1 Recording Schedule Interface
2. Check the checkbox of Enable to enable scheduled recording.
3. Click Advanced to set the camera record parameters.
Figure 11-2 Record Parameters
Pre-record: The time you set to start recording before the scheduled time or
the event. For example, if an alarm triggers recording at 10:00, and the
pre-record time is set as 5 seconds, the camera starts to record at 9:59:55.
The Pre-record time can be configured as No Pre-record, 5s, 10s, 15s, 20s, 25s,
30s or not limited.
To Next Page
Loading...
