Network Camera User Manual
105
11.4 Memory Card Detection
Purpose:
With memory card detection, you can view the memory card status, lock your
memory card, and receive notification when your memory card is detected abnormal.
Note: Memory card detection function is only supported by certain types of memory
cards and camera models. If this tab page doesn't show on your web page, it means
either that your camera doesn't support the function, or your installed memory card is
not supported for this function. You can contact the dealer or the retailer for the
information of memory card that supports the function.
Steps:
1. Enter Memory Card Detection configuration interface:
Configuration > Storage > Storage Management > Memory Card Detection
Figure 11-10 Memory Card Detection
2. View the memory card status on Status Detection tab.
Remaining Lifespan: It shows the percentage of the remaining lifespan. The
lifespan of a memory card may be influenced by factors such as its capacity and
the bitrate. You need to change the memory card if the remaining lifespan is not
enough.
Health Status: It shows the condition of your memory card. There are three status
descriptions, good, bad, and damaged. You will receive a notification if the health
status is anything other than good when the Arming Schedule and Linkage
Method are set.
Note: It is recommended that you change the memory card when the health status
To Next Page
Loading...
Need help?
General
