Network Camera User Manual
106
is not “good”.
3. Click R/W Lock tab to add a lock to the memory card.
With the R/W lock added, the memory card can only be read and write when it is
unlocked.
Figure 11-11 R/W Lock Setting
Add a Lock
(1) Select the Lock Switch as ON.
(2) Input the password.
(3) Click Save to save the settings.
Unlock
(1) If you use the memory card on the camera that locks it, unlocking will be
done automatically and no unlocking procedures are required on the part of
users.
(2) If you use the memory card (with a lock) on a different camera, you can go to
HDD Management interface to unlock the memory card manually. Select the
memory card, and click the Unlock button shown next to the Format button.
Then input the correct password to unlock it.
Notes:
• The memory card can only be read and written in when it is unlocked.
• If the camera, which adds a lock to a memory card, is restored to the
factory settings, you can go to the HDD Management interface to unlock
the memory card.
Remove the Lock
(1) Select the Lock Switch as OFF.
To Next Page
Loading...
Need help?
General
