User Manual of Network Fisheye Camera
56
alarm response action.
Steps:
1. Enter the Tamper-proof Settings interface:
Configuration > Advanced Configuration > Basic Event > Video Tampering
Figure 5-35 Tamper-proof Alarm
2. Check Enable Tamper-proof checkbox to enable the tamper-proof detection.
3. Set the tamper-proof area; refer to Task 1 Set the Motion Detection Area in
Section 5.6.1.
4. Click Edit to edit the arming schedule for tamper-proof. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection.
Refer to Task 2 Set the Arming Schedule for Motion Detection in Section 5.6.1.
5. Check the checkbox to select the linkage method taken for the tamper-proof.
Audible warning, notify surveillance center, send email and trigger alarm output are
selectable. Please refer to Task 3 Set the Alarm Actions for Motion Detection in
Section 5.6.1.
6. Click Save to save the settings.
5.6.3 Configuring Alarm Input
Steps:
1. Enter the Alarm Input Settings interface:
To Next Page
Loading...
