HIKVISION DS-2CD6362F-I - Handling Exception

User Manual of Network Fisheye Camera
58
also set a name for the alarm output (optional).
3. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or
Manual. The delay time refers to the time duration that the alarm output remains in
effect after alarm occurs.
4. Click Edit to enter the Edit Schedule Time interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection
Refer to Task 2: Set the Arming Schedule for Motion Detection in Section 5.6.1.
5. You can copy the settings to other alarm outputs.
6. Click Save to save the settings.
Figure 5-37 Alarm Output Settings
5.6.5 Handling Exception
Purpose:
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the cameras.
Steps:
1. Enter the Exception Settings interface:
Configuration > Advanced Configuration> Basic Event > Exception
2. Check the checkbox to set the actions taken for the Exception alarm. Refer to