User Manual of Network Fisheye Camera
81
Figure 9-9 Modify an IP
(3) Click the OK to finish modifying.
Delete an IP Address
Left-click an IP address from filter list and click Delete.
Delete all IP Addresses
Click Clear to delete all the IP addrsses.
5. Click Save to save the settings.
9.5 Security Service
Purpose:
Telnet service can be enabled / disabled for the remote login.
Steps:
1. Enter the Security Service interface:
Configuration >Basic Configuration> Security > Security Service
Or Configuration > Advanced Configuration> Security > Security Service
Figure 9-10 Security Service
2. Check the checkbox of Enable Telnet to enable the telnet service.
3. Click Save to save the settings.
Note: Telnet service is disabled by default.
9.6 Viewing Device Information
Enter the Device Information interface:
To Next Page
Loading...
