User Manual of Network Fisheye Camera
62
object entering the region.
Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the
object which can trigger the alarm. When the sensitivity is high, a very small
object can trigger the alarm.
Percentage: Range [1-100]. Percentage defines the ratio of the in-region part of
the object which can trigger the alarm. For example, if the percentage is set as
50%, when the object enters the region and occupies half of the whole region, the
alarm is triggered.
7. Repeat the above steps to configure other regions. Up to 4 regions can be set. You
can click the Clear button to clear all pre-defined regions.
8. Click the Edit button to set the arming schedule.
9. Select the linkage methods for intrusion detection, including Notify Surveillance
Center, Send Email, Upload to FTP, Trigger Channel and Trigger Alarm Output.
10. Click Save to save the settings.
5.7 Configuring Heat Map
Note: Heap map function can be configured by the iVMS-4200 software. For detailed
instructions of the software, please refer to the user manual of iVMS-4200.
Before you start:
Start the iVMS-4200, and add the fisheye camera to the software.
Purpose:
Heat map graphically represents the individual values contained in matrix data, such
as where the visitors have spent the time, using different colors, so as to visually show
you the most welcome and less-popular fields.
Heat Map Configuration
Steps:
1. Enter the Heat Map configuration interface using the iVMS-4200:
Device Management > Remote Config > Heat Map
To Next Page
Loading...
Need help?
General
Weight and Dimensions
