User Manual of Network Fisheye Camera
52
4. Click and drag the mouse in the live video window to draw the mask area.
Note: You are allowed to draw up to 4 areas on the same image.
5. Click Stop Drawing to finish drawing or click Clear All to clear all of the areas
you set without saving them.
6. Click Save to save the settings.
5.6 Configuring and Handling Alarms
This section explains how to configure the network camera to respond to alarm events,
including motion detection, video tampering, alarm input, alarm output, exception,
face detection, audio exception detection, intrusion detection, defocus detection, and
scene change detection, etc. These events can trigger the linkage methods, such as
Notify Surveillance Center, Send Email, Trigger Alarm Output, etc.
Note:
Check the checkbox of Notify Surveillance Center if you want to the alarm
information pushed to your mobile phone as soon as the alarm is triggered.
5.6.1 Configuring Motion Detection
Purpose:
Motion detection is a feature which can take alarm response actions and record the
video for the motion occurred in the surveillance scene.
Tasks:
1. Set the Motion Detection Area.
Steps:
(1)Enter the motion detection settings interface
Configuration > Advanced Configuration> Basic Event > Motion Detection
(2)Check the checkbox of Enable Motion Detection.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
