DS-6700HUHI-K Series Encoder User Manual
53
To trigger an external alarm output when an event occurs, you need to go to the Alarm Output Settings
to set the related parameters. Refer to Chapter 7.1.3 Configuring Alarm Output for reference.
(4) Select the channel you want to trigger recording when a motion detection event occurs.
Figure 7. 6 Motion Detection-Alarm Linked Recording
8. Click Save to save the settings.
7.1.2 Configuring Alarm Input
Steps:
1. Go to Configuration> Event > Basic Event > Alarm Input to enter the Alarm Input Settings page.
2. Select the Alarm Input No.
3. Select the Alarm Type. The alarm type can be NO (Normally Open) and NC (Normally Closed).
4. Enter the Alarm Name.
5. Check Enable Alarm Input Handling.
6. Click Arming Schedule tab to set the arming schedule for the alarm input. Please refer to Step 6 in Chapter
7.1.1 Configuring Motion Detection.
To Next Page
Loading...
