HIKVISION DS-7108HGHI-K1

Edit Connected Network Camera
You can edit the IP address, protocol and other parameters of the added network cameras.
Steps
1.
Go to Conguraon → Camera → IP Camera .
2.
Click
to edit the selected camera.
Channel Port
If the connected device is an encoding device with mulple channels, you can select the
channel port No. to choose a
connecng channel.
3.
Click OK.
5.3.2
Moon
Moon enables the video recorder to detect the moving objects in the monitored area and trigger
alarms.
Steps
1.
Go to Conguraon → Camera → Moon .
2.
Select a camera.
3.
Check Enable.
4.
Set the
moon area：Click Draw Area or Clear to draw or clear areas.
Note
The operaon may dier according to dierent models.
5.
Adjust Sensivity. Sensivity allows you to calibrate how readily movement triggers the alarm. A
higher value results in the more readily to triggers
moon.
6.
Set analysis mode as AI or PIR.
AI
The
moon event will be analyzed by your device.
PIR
The moon event will be analyzed by certain analog PIR cameras.
7.
Oponal: Set Detecon Target as Human or Vehicle to discard alarms which are not triggered
by human or vehicle.
8.
Set the arming schedule. Refer to
Congure Arming Schedule for details.
9.
Set the linkage
acons. Refer to Congure Alarm Linkage Acon for details.
10.
Click Apply.
Digital Video Recorder User Manual
27