HIKVISION DS-7108HI series - Video Output Standard and VGA Setup

43
5.4 Video Output Standard and VGA Setup
Video output standard
There is one VOUT BNC connector at the rear panel of DVR. It is used to
connect with analog monitor and can support PAL or NTSC video output. You can
modify video output standard to match video input.
In “Display” menu: There is a list box named “Video Output Standard”, you can
use【Ç】【È】key to select PAL or NTSC video output.
VGA setup
There is one VGA interface at the rear panel of DVR. You can use it to connect
with VGA display. You can define VGA resolution, refresh frequency in “Display”
menu.
There are following options: 1280*1024/60Hz,1024*768/60Hz, 800*600/60Hz.
You can use【Ç】【È】key to select.
Press “Confirm” button to save or “Cancel” to abort.