5.22 Alarms setup
xternal alarm input setup:
n” or “Normal Close” according to the
em. One is “Ignore”,
and the other is “Handle”. If you select “Handle” option, you can active “Policy” and “PTZ
Link
larm in Handling” sub menu: Shown as fig 5.23
E
Step 1: Select one alarm input Use【↑】【↓】keys to select one alarm input.
Step 2: Alarm type
This is sensor type. You can select “Normal Ope
sensor type.
Step 3: Enter into “Alarm in Handling” sub menu
In the “Alarms” menu, there are two options for “Alarm Handling” it
age” buttons on right side. Move “Active Frame” to “Policy” button and press【ENTER】key,
you will enter into “A
63
To Next Page
Loading...
