Quick Operation Guide of Digital Video Recorder
56
DS-9000/8000HFI-ST & 9000HFI-RT/XT & 9000/8000HWI-ST & 7600HI-ST
Note: IP Camera is supported by DS-9000/8000HFI-ST & 9000HFI-RT/XT & 9000/8000HWI-ST & 7600HI-ST
series DVR.
14. Click OK to complete the startup Setup Wizard.
Live View
Some icons are provided on screen in Live View mode to indicate different camera status. These icons include:
Live View Icons
In the live view mode, there are icons at the right top of the screen for each channel, showing the status of the
record and alarm in the channel, so that you can find problems as soon as possible.
Alarm (video loss, tampering, motion detection or sensor alarm).
Record (manual recording, continuous recording, motion detection or sensor alarm triggered recording).
Alarm & Record
Note: Sensor alarm is not supported by DS-7200HFI/HWI-SV series.
PTZ Control
Follow the procedure to set the parameters for PTZ. The configuring of the PTZ parameters should be done before
you set the PTZ camera.
Before you start, please check that the PTZ and the DVR are connected properly through RS-485 interface.
PTZ Settings
To configure PTZ settings:
1. Enter the PTZ Settings interface.
Menu >Camera> PTZ
To Next Page
Loading...
Need help?
General