Network Video Recorder User Manual
119
Set Motion Detection
Select the camera to configure the motion detection.
Check Enable.
Set the motion detection area.
Full screen: Click to set the full-screen motion detection for the image.
Customized area: Click-and drag the mouse to click and drag on the preview screen to draw the
customized motion detection area (s).
Click Clear to clear the current motion detection area settings and draw again.
Set sensitivity (0-100). The sensitivity allows you to calibrate how readily movement triggers the
alarm. A higher value results in the more readily to triggers motion detection.
Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
To Next Page
Loading...
