Network Video Recorder User Manual
40
After the device is activated, you should properly keep the password.
You can duplicate the password to the IP cameras that are connected with default protocol.
Configure Login Unlock Pattern
You can configure a device login unlock pattern for the admin user.
After the device is activated, enter the following interface to configure the device unlock pattern.
Use the mouse to draw a pattern among the 9 dots on the screen. Release the mouse when the
pattern is done.
Draw the Pattern
Connect at least 4 dots to draw the pattern.
Each dot can be connected for once only.
Draw the same pattern again to confirm it. When the two patterns match, the pattern is
configured successfully.
If the two patterns are different, you must set the pattern again.
To Next Page
Loading...
Need help?
General
