HIKVISION DS-9600NI-I8 Series User Manual

Network Video Recorder User Manual
25
DS-7600NI Series
DS-7600NI Series
Panel Description
IR Remote Control Operations
The device may also be controlled with the included IR remote control, shown in Figure 1-5.
Batteries (2×AAA) must be installed before operation.
The IR remote is set at the factory to control the device (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
devices. You may also pair an IR Remote to a specific device by changing the Device ID#, as follows:
Pairing (Enabling) the IR Remote to a Specific Device
(optional)
You can pair an IR Remote to a specific device by creating a user-defined Device ID#. This feature is
useful when using multiple IR Remotes and devices.
On the device:
Go to System > General.
Type a number (255 digits maximum) into the Device No. field.
On the IR Remote:
No.
Name
Connections
1
POWER
Turns green when device is powered up.
2
HDD
Flickers red when data is being read from or written to HDD.
3
Tx/Rx
Flickers blue when network connection is functioning
properly.
4
USB Interface
Universal Serial Bus (USB) port for additional devices such as
USB mouse and USB Hard Disk Drive (HDD).

HIKVISION DS-9600NI-I8 Series Specifications

General

Brand	HIKVISION
Model	DS-9600NI-I8 Series
Category	Network Hardware
Language	English