Access Control Terminal·Quick Start Guide
27
6 Basic Operation
Before You Start:
You should activate the device before the first login. Otherwise, after powered on,
the system will switch into activaon notifying interface. For detailed information
about activation, see Chapter 5.
Figure 6-1 Activation Notifying Interface
You should enter the default password for the first login.
Enter System Settings -> System Parameter –> Login Password to reset the login
password.
The default password is 12345.
Steps:
1. The device enters the initial interface automatically after powered on.
Figure 6-2 Initial Interface
2. Long-click the # key to enter the password authentication interface.
To Next Page
Loading...
