Access Control Terminal·Quick Start Guide
34
6.2 Communication Settings
Purpose:
On the communication settings interface, you can set network parameters, the serial
port, Wiegand parameters, and Wi-Fi.
Steps:
1. Move the cursor to Comm (communication settings) by using direction keys.
2. Click the # key to enter the communication settings interface.
Figure 6-13 Communication Settings Interface
Network Settings: It refers to network parameters of the device, including IP address,
subnet mask, and gateway address.
Serial Port Settings: When the access control terminal works as a RS485 card reader,
serial port parameters include working mode, Baud Rate, and RS485 address.
Wiegand Settings: When the access control terminal works as a Wiegand card reader,
Wiegand parameters involve whether to enable the Wiegand connection, and the
Wiegand mode.
Wi-Fi: You can enable the Wi-Fi function.
6.2.1 Network Settings
Purpose:
On the network settings interface, you can set network parameters of the device.
Steps:
1. Move the cursor to Network (network settings) by using direction keys.
2. Click the # key to enter the network settings interface.
To Next Page
Loading...
