HIKVISION DS-K1T501SF User Manual

Video Access Control Terminal·User Manual
84
2. You can editing the following parameters:
 Nickname: Edit the card reader name as desired.
 Enable Card Reader: Select Yes to enable the card reader.
 OK LED Polarity: Select the OK LED Polarity of the card reader mainboard.
 Error LED Polarity: Select the Error LED Polarity of the card reader mainboard.
 Buzzer Polarity: Select the Buzzer LED Polarity of the card reader mainboard.
 Minimum Card Swiping Interval: If the interval between card swiping of the same card is
less than the set value, the card swiping is invalid. You can set it as 0 to 255.
 Max. Interval When Inputting Password: When you inputting the password on the card
reader, if the interval between pressing two digits is larger than the set value, the digits
you pressed before will be cleared automatically.
 Enable Failed Attempts Limit of Card Reading: Enable to report alarm when the card
reading attempts reach the set value.
 Max. Times of Card Swiping Failure: Set the max. failure attempts of reading card.
 Enable Tampering Detection: Enable the anti-tamper detection for the card reader.
 Detect When Card Reader is Offline for: When the access control device cannot connect
with the card reader for longer than the set time, the card reader will turn offline
automatically.
 Buzzing Time: Set the card reader buzzing time. The available time ranges from 0 to 5999s.
0 represents continuous buzzing.
 Card Reader Type: Get the card reader’s type.
 Card Reader Description: Get the card reader description.
 Fingerprint Recognition Level: Select the fingerprint recognition level in the dropdown list.
By default, the level is Low.
3. Click the Save button to save parameters.

HIKVISION DS-K1T501SF Specifications

General

Type	Basic access control reader
Product color	Gray
Cards capacity	50000 cards
Housing material	Metal
Keypad integrated	No
Fingerprint reader	Yes
Authentication type	Access chip/card, Biometric, Face recognition
Transaction capacity	200000
Fingerprint sensor type	Optical
Identification (1:N) time	1.5 s
False Rejection Rate (FRR)	0.01 %
False Acceptance Rate (FAR)	0.001 %
Access chip/card reader type	Contactless
International Protection (IP) code	IP65
DC current (max)	600 A
DC voltage range	12 V
Total megapixels	2 MP
Front camera type	Single camera
PC connected	-
RS-485 ports	1
Operating temperature (T-T)	-40 - 70 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	218 mm
Width	78 mm
Height	41 mm