Face Recognition Terminal Quick Start Guide
12
2. Drill holes on the wall or other surface according to the mounting template and install the gang
box (80mm×80mm).
3. Use two supplied screws to secure the mounting plate on the gang box.
4. Use another four supplied screws to secure the mounting plate on the wall.
5. Remove the screw at the bottom of the device.
6. Align the terminal with the mounting plate and buckle them together.
7. Use a hex wrench to fasten the screw at the bottom.
Notes:
The installation height here is the recommended height. You can change it according to your
actual needs.
For easy installation, drill holes on mounting surface according to the supplied mounting
template.
3.2 Installing without Gang Box
Steps:
1. According to the basline on the mounting template, stick the mounting template on the wall or
other surface, 1.3 meters higher than the ground.
To Next Page
Loading...
Need help?
General
