HIKVISION DS-K1T604M - General Parameters Settings; Communication Settings

Face Recognition Terminal Quick Start Guide
22
Notes:
 The device will be locked for 30 minutes after 5 failed password attempts.
 For details about setting the administrator authentication mode, see 5.4.1 Adding User.
5.3 General Parameters Settings
5.3.1 Communication Settings
Purpose:
You can set the network parameters, the RS-485 parameters, and the Wiegand parameters on the
communication settings page.
Tap Comm. (Communication Settings) on the Home page to enter the Communication Settings
page.
Setting Network Parameters
Purpose:
You can set the device network parameters, including the IP address, the subnet mask, and the
gateway.
Steps:
1. On the Communication Settings page, tap Network to enter the Network tab.