Face Recognition Terminal Quick Start Guide
24
Note: If you change the external device, and save the device parameters, the device will reboot
automatically.
Setting Wiegand Parameters
Purpose:
You can set the Wiegand transmission direction.
Steps:
1. On the Communication Settings page, tap Wiegand to enter the Wiegand tab.
2. Tap the slider to enable the Wiegand function.
3. Select the transmission direction.
Transmission Direction:
Output: A face recognition terminal can connect an external access controller. And the two
devices will transmit the card No. via Wiegand 34.
Input: A face recognition terminal can connect a Wiegand card reader.
4. Tap √ to save the Wiegand parameters and go back to the Home page.
5.3.2 System Settings
Purpose:
On the System Settings page, you can set the system basic parameters, the face parameters, the
fingerprint parameters, and upgrade the firmware.
On the Home page, tap System (System Settings) to enter the System Settings page.
Setting Basic Parameters
Purpose:
You can set the building No. and the unit No., voice prompt, voice volume, read CPU file,
application mode, live view in IR mode, auto adjust white light brightness, supplement light
brightness (Infrared Light), and supplement light brightness (white light).
To Next Page
Loading...
