Face Recognition Terminal Quick Start Guide
41
5.8.2 Calling Device from iVMS-4200 Client Software
Steps:
1. Get the client software from the supplied disk or the official website, and install the software
according to the prompts.
2. Run the client software and the control panel of the software pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the device to the client software.
Note: For details about adding device, see Adding Access Control Device in the user manual.
5. Enter the Live View page and double-click the added device to start live view.
Note: For details about operations in the Live View page, see Live View in the user manual.
6. Right click the live view image to open the right-click menu.
7. Click Start Two-Way Audio to start two-way audio between the device and the client software.
To Next Page
Loading...
Need help?
General
