HIKVISION DS-K1T642MFW User Manual

It refers to the port of real-me streaming protocol.
HTTPS
Set the HTTPS for accessing the browser. Cercate is required when accessing.
Server
It refers to the port through which the client adds the device.
Set Wi-Fi Parameters
Set the Wi-Fi parameters for device wireless connecon.
Steps
Note
The funcon should be supported by the device.
1.
Click Conguraon → Network → Basic Sengs → Wi-Fi .
Figure 8-6 Wi-Fi Sengs Page
2.
Check Wi-Fi.
3.
Select a Wi-Fi
-
Click of a Wi-Fi in the list and enter the Wi-Fi password.
-
Click Add and enter a Wi-Fi's name, password, and
encrypon type. Click Connect. When the
Wi-Fi is connected, click OK.
4.
Oponal: Set the WLAN parameters.
1) Click TCP/IP
Sengs.
2) Set the IP address, subnet mask, and default gateway. Or check Enable DHCP and the system
will allocate the IP address, subnet mask, and default gateway
automacally.
5.
Click Save.
Face Recognion Terminal User Manual
74

HIKVISION DS-K1T642MFW Specifications

General

Type	-
Log capacity	150000
Product color	Black
Cards capacity	10000 cards
RFID frequency	13.56 MHz
Languages support	ARA, ENG, ESP, THA, POR, RUS, VIE
Recommended usage	Indoor
Fingerprint reader	Yes
Authentication type	Access chip/card, Biometric, Face recognition
Access chip/card reader type	Contactless
RS-485 ports	1
Cabling technology	10/100/1000
Supported network protocols	ISUP 5.0, ISAPI, NetSDK, HikCentral Pro OpenAPI, Hik-ProConnect OpenAPI
Display diagonal	4.3 \
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	0 - 90 %
Total megapixels	2 MP
Front camera type	Dual camera
Viewing angle, vertical	75.5 °
Viewing angle, horizontal	41.5 °

Weight and Dimensions

Depth	20 mm
Width	118 mm