To Next Page

To Previous Page

Enable to report alarm when the card reading aempts reach the set value.

Max. Authencaon Failed Aempts

Enable to report alarm when the card reading aempts reach the set value.

Communicaon with Controller Every

When the access control device cannot connect with the card reader for longer than the set

me, the card reader will turn oine automacally.

Max. Interval When Entering Password

When you entering the password on the card reader, if the interval between pressing two digits

is longer than the set value, the digits you pressed before will be cleared

automacally.

OK LED Polarity/Error LED Polarity

Set OK LED Polarity/Error LED Polarity of the access control device according to the card reader

parameters. Generally, adopts the default sengs.

Enable Tampering Detecon

Enable the an-tamper detecon for the card reader.

Set Privacy Parameters

Set the event storage type, picture upload and storage parameters, and the picture clearing

parameters.

Go to Conguraon → General → Privacy .

Event Storage

Sengs

Select a method to delete the event. You can select from Delete Old Events Periodically, Delete

Old Events by

Specied Time, or Overwring.

Delete Old Events Periodically

Drag the block or enter number to set the period for event deleng. All events will be deleted

according to the

congured me duraon.

Delete Old Events by Specied Time

Set a me and all events will be deleted on the congured me.

Overwring

The earliest 5% events will be deleted when the system detects the stored events has been over

95% of the full space.

Authencaon

Sengs

Display Authencaon Result

You can check Face Picture, Name, Employee ID and Temperature, to display the authencaon

result.

DS-K1T6QT-F43 Series Face Recognion Terminal User Manual

123

HIKVISION DS-K1T6QT-F43EW User Manual

Questions and Answers: