HIKVISION DS-K1T6QT-F43EW

Figure 9-14 Wiegand Page
2.
Check Wiegand to enable the Wiegand funcon.
3.
Set a transmission direcon.
Input
The device can connect a Wiegand card reader.
Output
The can connect an external access controller. And the two devices will transmit the card No.
via Wiegand 26 or 34.
4.
Click Save to save the
sengs.
Note
If you change the peripheral, and aer you save the device parameters, the device will reboot
automacally.
9.6.22 Set Biometric Parameters
Set Basic Parameters
Click Conguraon → Smart → Smart .
DS-K1T6QT-F43 Series Face Recognion Terminal User Manual
131