HIKVISION DS-KH9510-WTE1 Configuration Guide

DS-KH9510-WTE1 Video Intercom Indoor Station Configuration Guide
CG DS-KH9510-WTE1 Video Intercom 031621NA 23
will receive alarm message when the detector is triggered.
Under disarming mode, it will not receive alarm message when the detector is triggered.
When the zone type is set to be 24H Alarm, the indoor station will receive alarm message
when the detector is triggered no matter it is under arming mode or disarming mode.
When the zone type is set to be Delay Alarm, only under arming mode, the indoor station will
receive alarm message when the detector is triggered. Under disarming mode, it will not
receive alarm message when the detector is triggered.
After setting enter delay time, if OK is pressed within the enter delay time after the alarm,
the alarm event will not be uploaded to the management center; if OK is not pressed within
the enter delay time after the alarm, the alarm event will be uploaded to the management
center.
The exit delay is the time between you enable the arming mode and the arming takes effect.
IP Camera Information
You can add, delete and modify cameras that can be added to the video intercom products, with two ways
of getting stream: direct or URL. By exporting and importing the added device information, you can edit
added devices parameters in batch.
Add Camera
Steps
1. Click IP Camera Information to enter IP camera information page.
Figure 23, Camera Information
2. Click Add to pop up the device adding dialog box.
3. Enter corresponding information (device name, IP address, port No., user name, password, etc.), and
click OK.
NOTE: Indoor extension does not support this function.
Export and Import Added Device Information
Steps
1. Click Export to export the added device information file.
2. Edit parameters of added devices in batch in the exported file.
3. Click Import to pop up importing box, and open the edited added device information file.

HIKVISION DS-KH9510-WTE1 Specifications

General

Product type	Master station
Product color	White
Display resolution	1024 x 600 pixels
Brand compatibility	Hikvision
Quantity per pack	1 pc(s)
Operating temperature (T-T)	-10 - 50 °C

Weight and Dimensions

Depth	166 mm
Width	254 mm
Height	26.65 mm