Panic Alarm Station User Manual
51
Steps
1. Enable SIP.
Enrollment Status
Display the device enrollment status. If the device has been enrolled to the SIP server, it
displays Enrolled. Otherwise it displays Not Enrolled.
2. Select IPv4 or Domain.
3. Set parameters.
User Information
You can enter IP, Server Port, User Name, Enrollment Password, etc.
Local Port
The default local port is 5060.
4. Click Save.
Device Access – Hik-Connect
Ezviz is a micro video service platform. After enrolling devices to Ezviz platform, you can access the
devices through Ezviz.
Steps
1. Click Network → Device Access → Hik-Connect.
2. Enable Ezviz Cloud.
Note
● When it is enabled for the first time, you need to set the verification code.
3. Set Server Address. You can select default or custom.
When Custom is checked, you need to set the server address manually. You can contact the
technical support to get the address.
4. Set Network Mode. The default mode is wired network.
5. Enter the set verification code. The code is a 6-sigit random code used for QR code encryption. It
can be set to 6~12 characters and supports English letters (case sensitive) and numbers. It is
recommended to combine more than 8 digits of numbers and letters.
6. Click View to see the Hik-Connect QR code.
7. Click Save.
Device Access - ISUP
ISUP platform refers to Intelligent Security Uplink Protocol.
Steps
1. Click Network → Device Access → ISUP.
2. Enable ISUP.
3. Select Protocol Version as Ehome2.0 or ISUP5.0.
4. Select Server Type as IPv4 or Domain.
5. Set parameters.
Port
The default port number is 7660. The range is 2000 to 65535.
To Next Page
Loading...
