Panic Alarm Station User Manual
60
Audio&Video Self-Test
Click Maintenance and Security → Maintenance → Audio&Video Self-Test, set manual test or auto
test.
Auto Test
Audio and video self-test will be automatically performed according to the set detection time.
Restore to Default Settings
Click Test, the results will be shown in the result table.
IP Address Filter
Steps
1. Click Maintenance and Security → Security → IP Address Filter.
2. Enable filter, click +Add to add IP address to the list.
3. Click to change IP address. Click to delete address.
4. Click Save.
Block List
The IP address in this list will be blocked. Other IP address can communicate normally.
Allow List
Only the IP address in this list can communicate normally. Other IP address will be blocked.
Note
● You can only enable one kind of list.
Security Service
Click Maintenance and Security → Security → Security Service.
Enable SSH, and click Save.
Note
● SSH is used for remote debugging. For your safety, it is recommended to disable SSH when it is
not needed.
To Next Page
Loading...
Need help?
General
