Need help?Do you have a question about the HIKVISION HWD Series and is the answer not in the manual?
General| Operating System | Embedded Linux |
|---|---|
| Video Compression | H.264, H.265 |
| Video Input | 4/8/16 channels |
| Video Output | 1 HDMI, 1 VGA |
| Audio Output | 1 channel |
| Network Interface | 1 RJ45 10M/100M Self-Adaptive Ethernet Interface |
| USB Interface | 2 USB 2.0 |
| HDD Interface | SATA |
| Power Supply | 12 VDC |
| Mobile Access | Hik-Connect |
| Encoding Resolution | 1080p, 720p, VGA, WD1, 4CIF, CIF |
Details the physical layout and indicators of the DVR's front panel.
Explains how to use the infrared remote control for device operation and navigation.
Describes the various ports and connectors available on the rear of the DVR unit.
Covers the essential procedures for powering the DVR on and off safely.
Guides through the initial activation process, including setting an admin password.
Outlines the initial setup steps performed via the startup wizard.
Explains how to log in to the device and log out to secure the system.
Details how to view live video feeds, switch screens, and start recording.
Covers the initial configuration of parameters required for PTZ camera control.
Details how to set video encoding parameters like resolution, bitrate, and frame rate.
Covers various methods for searching and playing back recorded video files.
Guides on configuring motion detection parameters, areas, and sensitivity.
Explains how to configure face detection rules, sensitivity, and linkage actions.
Covers essential network parameters like IP address, gateway, and DNS settings.
Guides on the process of initializing newly installed hard disk drives for use.
Covers procedures for upgrading the DVR's firmware via local backup or FTP.
Offers solutions for common problems encountered during DVR operation and setup.
To Next Page