HIKVISION iDS-TCV907-BIR

Steps
1.
Go to Conguraon → Network → Data Connecon → SDK Listening .
Figure 4-3 Set SDK Listening
2.
Enable SDK listening.
3.
Set IP Address/Domain and Port if you need to upload the alarm informaon and pictures.
4.
Select Protocol Type.
Note
Supported funcons vary with dierent models. The actual device prevails.
License Plate Upload Protocol
Uploads arming alarm images of the license plate. You can enable Upload Binary Image if you
need to upload images which are full of black or white pixel points. Enable Output Binary
Image in BMP Format if you want to output images in this format.
Mixed Target Upload Protocol
Uploads images of
mulple targets such as humans and vehicles. You can enable the body
property to recognize clothes, bags, and other
properes.
5.
Oponal: If you want to save the alarm informaon and pictures to the cloud storage, click to
set Cloud Storage. Refer to
Set Cloud Storage for details.
6.
Click Save.
4.1.4 Set Arm Host
The device can upload the captured pictures via the arm host.
Steps
Note
For level 1 arm, the pictures can be uploaded normally. If uploading failed, the device will upload
again. For level 2 arm, the pictures will be uploaded once. No more upload if uploading failed. For
level 3 arm, pictures will not be uploaded.
1.
Go to Conguraon → Network → Data Connecon → Arm Upload .
Network Trac Camera Operaon Manual
16