HIKVISION iDS-TCV907-BIR

Steps
1.
Go to Conguraon → Network → Network Parameters → DDNS .
Figure 6-4 Set DDNS
2.
Check Enable DDNS.
3.
Enter the server address and other informaon.
Note
You can select IPServer, DynDNS, and NO-IP for the DDNS type.
4.
Click Save.
5.
Access the device.
By Browsers
Enter the domain name in the browser address bar to access the device.
By Client Soware Add domain name to the client soware. Refer to the client soware
manual for specic adding methods.
6.4 Set SNMP
You can set the SNMP network management protocol to get the alarm event and excepon
messages in network transmission.
Before You Start
Download the SNMP soware and manage to receive the device informaon via SNMP port.
Steps
1.
Go to Conguraon → Network → Network Parameters → SNMP .
2.
Check Enable SNMPv1/Enable SNMP v2c/Enable SNMPv3.
Network Trac Camera Operaon Manual
36