HIKVISION iDS-TCV907-BIR

Before You Start
●
Connect the device to the Internet.
●
Set the IP address, subnet mask, gateway, and DNS server of the LAN.
Steps
Note
This funcon varies with dierent models. The actual device prevails.
1.
Go to Conguraon → Network → Data Connecon → Hik-Connect Plaorm .
2.
Check Enable.
Figure 6-3 Connect to Hik-Connect
3.
Select Plaorm Access Mode.
4.
Enter a custom
Vericaon Code used to add the device via Hik-Connect.
Cauon
The vericaon code should be 6 leers or numbers, case sensive. You are recommended to
use a combinaon of leers or numbers.
5.
Click Save.
6.
Register an account and add the device to Hik-Connect.
Note
Refer to the user manual of the plaorm for details.
6.3 Set DDNS
You can use the Dynamic DNS (DDNS) for network access. The dynamic IP address of the device can
be mapped to a domain name
resoluon server to realize the network access via domain name.
Before You Start
●
Register the domain name on the DDNS server.
●
Set the LAN IP address, subnet mask, gateway, and DNS server parameters. Refer to Set IP
Address for details.
●
Complete port mapping. The default ports are 80, 8000, and 554.
Network Trac Camera Operaon Manual
35