HIKVISION K1108AMK Series - Chapter 4 Sound Prompt and Indicator

Chapter 4 Sound Prompt and Indicator
Aer the card reader is powered on, LED status indicator will turn green and ashing for 1 me.
Then it will turn red and ashing for 3 mes. At last the buzzer will send out a beep sound
indicang the starng up process is completed.
When using the card reader, it will send out dierent sounds prompt and the LED indicator on it
will have
dierent statuses. You can refer to tables below for detailed informaon.
Table 4-1 Descripon of Prompt Sound
Sound Prompt Descripon
One Beep Presenng card prompt
Pressing keys prompt
Prompt of pressing key for too long me when inpung card
No.
Time out prompt for pressing keys or presenng card.
For authencaon: prompt for entering the password aer
presenng the card.
Two Rapid Beeps The operaon of pressing keys or swiping card is valid.
Three Slow Beeps The operaon of pressing keys or swiping card is invalid.
Rapidly Connuous Beeps Prompt for tamper-proof alarm.
Prompt for buzzer alarm.
Slowly Connuous Beeps The card reader is unencrypted.
Table 4-2 Descripon of LED Switch
LED Indicator Status Descripon
Flashing Green for 1 Time and
Flashing Red for 3 Times
The card reader is power on.
Flashing Green For Card + Password authencaon: prompt for entering the
password aer presenng the card.
Solid Green for 2 s The operaon of pressing keys or presenng card is valid.
Solid Red Card reader is working normally.
Flashing Red for 3 Times The operaon of pressing keys or presenng card is invalid.
Flashing Red For RS-485 protocol: Registering failed or card reader is oine.
Card Reader User Manual
8