HIKVISION K1108AMK Series - Set RS-485 Communication Mode

Color Descripon
Gray TAMPER Control
Purple Beep Control (Available for Wiegand Protocol)
3.3.2 Set RS-485 Communicaon Mode
Steps
1. Set the DIP switch of No. 6 as 0.
2. Set the DIP switch of No. 1 ~ 5 for RS-485 address and reading card mode. For details, refers to
DIP Switch
Descripon .
3. Wire the cable between controller and card reader as shown below.
Figure 3-2 Wiring for RS-485 Communicaon Mode
Card Reader User Manual
6