•
When the z
one type is set to be Delay Alarm, only under arming mode, the
indoor statio will receive alarm message when the detector is triggered.
Under disarming mode, it will not r
eceive alarm message when the detector
is triggered.
•
Afte
setti enter delay time if OK is pressed within the enter delay tim
afte the alarm, the alarm event will not be uploaded to the management
center; if OK is not pressed within the enter delay tim afte the alarm, the
alarm event will be uploaded to the management center.
•
The exit delay is the tim between you enable the arming mode and the
arming t
akes e ect.
IP Camera Informatio
You can add, delete and modify cameras that can be added to the video intercom
pr
oducts, with two ways of getti stream: direct or URL. By exportin and importin
the added device information you can edit added devices parameters in batch.
Add Camera
Steps
1.
Click IP Camera Informatio to enter IP camera informatio page.
Figure 2-16 IP Camera Informatio
2.
Click Add to pop up the device adding dialog box.
3.
Enter corresponding informatio (device name, IP address, port No., user name,
pass
word, etc.), and click OK.
Note
Indoor extension does not support this function
Export and Import Added Device Informatio
Network Indoor Statio Configu atio Guide
31
To Next Page
Loading...
Need help?
General
