VIEWING TELEPHONE NUMBERS
You may wish to check the phone numbers that have been programmed for your security
system.
Key Sequence Operation
Example shows viewing phone
number 1.
1. Press [*] and [4] [1] for phone
number 1.
2. Enter the master code. You are
now in the view mode, and the first
phone digit will be displayed. (Use
the following table to read the code
pad lights).
3. Press the [*] key to move to the
next digit(s).
4. Press [#] to end and exit.
*
4 1
31 2 4
*
#
Zone Light Phone Digit Light Phone Digit
Zone 1 1 [Fire] 9
Zone 2 2 [Service] 0
Zone 3 3 [On] Star (*)
Zone 4 4 [Partial] Hash (#)
Zone 5 5 [Exit] 4 Sec Delay
Zone 6 6 [Bypass] Disable
Zone 7 7 [Chime] Pulse Dialling
Zone 8 8
Zone 9 9
Zone 10 0
Cancelling Alarm Calls
Note: Alarm calls will be heard as siren tone – pause - siren tone, this will
repeat several times. You can stop the alarm system calling you, or any
further programmed numbers, by pressing the star key for 2 seconds during
the pause period of the call. This will also end the current call.
V2.02
Page 18
To Next Page
Loading...
