CODE PAD CONTROL TONES
• Beeps for all key presses Sounds a continuous tone during the entry delay time.
• Pulses when a day zone is violated while the system is disarmed.
• Pulses when a fire zone has a trouble condition.
• Beeps 3 times for trying to arm with the “Ready” light off, if “Force Arming” has not been
selected.
• Beeps for 1 second or emits a “ding-dong” sound for the “Chime” feature.
• Beeps during an exit delay; beeps rapidly for the last 10 seconds of an exit delay; and
beeps 1 second at the end of the exit delay.
• Pulses when the armed status changes and the AC power is off.
• Pulses when the armed status changes and any zone(s) is bypassed.
• Pulses when the armed status changes and a low battery is detected.
• Pulses when the armed status changes and a tamper condition is detected. Beeps to
indicate telephone line cut, if selected.
• Pulses when one or more of the following conditions are detected: zone or box tamper,
low battery, AC power fail, or expander trouble.
Entering a valid code will silence the code pad sounder when it is pulsing. Please
contact your installer if a trouble condition exists.
V2.02
Page 6
To Next Page
Loading...
