What to do if 1 LED flashes and the Hilti SF 6-A22 Drill doesn't work?
If only 1 LED flashes and your Hilti Drill/Driver isn't working, the battery might be discharged. Try changing the battery and charging the empty one. The battery could also be too cold or too hot. Bring the battery to the recommended working temperature.
Why my Hilti Drill doesn't work?
Your Hilti Drill might not be working because the battery isn't correctly inserted. Ensure the battery is properly inserted. Alternatively, the battery could be discharged, so try changing the battery and charging the empty one.
Why does my Hilti SF 6-A22 not work?
Your Hilti Drill/Driver might not be working because the battery isn't correctly inserted. Ensure the battery is properly inserted. Alternatively, the battery could be discharged. In that case, change the battery and charge the empty one.
What to do if all 4 LEDs flash and the Hilti SF 6-A22 Drill doesn't work?
If your Hilti Drill/Driver doesn't work, and all 4 LEDs are flashing, it might have been briefly overloaded. Try releasing the control switch and then pressing it again. Also, overheating could be the cause. Allow the drill/driver to cool down, and then clean the air vents.
What to do if the control switch is stuck on my Hilti SF 6-A22?
If the control switch on your Hilti Drill cannot be pressed or is stuck, the forward/reverse selector switch may be in the middle (transport) position. Set the forward/reverse selector switch to forward or reverse rotation, as applicable.
What does it mean when 1 LED flashes on my Hilti SF 6-A22 Drill?
If 1 LED flashes and your Hilti Drill isn't working, the battery may be discharged. Try changing the battery and charging the empty one. The battery might also be too cold or too hot. Bring the battery to the recommended working temperature.
How to fix a Hilti SF 6-A22 Drill that won't turn on?
If your Hilti Drill isn't working, make sure the battery is correctly inserted. If that's not the issue, the battery might be discharged. Try changing the battery and charging the empty one.
Why is my Hilti SF 6-A22 Drill getting so hot?
If your Hilti Drill/Driver is getting very hot, it could be due to an electrical fault, in which case you should immediately switch off the drill/driver, remove the battery, and contact Hilti Service. Alternatively, the drill/driver may be overloaded, meaning the application limit has been exceeded, so check the application.
What to do if all 4 LEDs flash on my Hilti SF 6-A22?
If all 4 LEDs are flashing and your Hilti Drill isn't working, it may have been briefly overloaded. Try releasing the control switch and then pressing it again. It could also be due to overheating. Allow the drill to cool down and then clean the air vents.
How to troubleshoot if my Hilti Power Tool drill / driver doesn’t work?
If your Hilti power tool drill/driver isn't working, make sure the battery is fitted correctly. If it is, the battery might be low. Try changing the battery and charging the empty one.
General| Tool type | Cordless Drill Driver |
|---|---|
| Battery voltage | 21.6 V |
| Chuck capacity | 1.5 - 13 mm |
| Number of gears | 2 |
| Battery Type | Li-ion |
| Chuck type | Keyless chuck |
Illustrates and explains symbols found directly on the product.
Essential safety guidelines and precautions for operating power tools.
General safety guidelines applicable to all drilling tasks.
Specific safety advice for working with long drill bits.
Key technical specifications for both tool models.
Steps for correctly installing the battery into the tool.
Procedure for safely detaching the battery from the tool.
Instructions for safely and correctly charging the battery.
Guide for securely attaching the auxiliary side handle.
Common issues and solutions for the power tool.
To Next Page
