Hilti TE 70-ATC User Manual

*2244432*
2244432 English 1
Original operating instructions
1 Information about the documentation
1.1 About this documentation
• Read this documentation before initial operation or use. This is a
prerequisite for safe, trouble-free handling and use of the product.
• Observe the safety instructions and warnings in this documentation and
on the product.
• Always keep the operating instructions with the product and make sure
that the operating instructions are with the product when it is given to
other persons.
1.2 Explanation of symbols
1.2.1 Warnings
Warnings alert persons to hazards that occur when handling or using the
product. The following signal words are used:
DANGER
DANGER !
▶ Draws attention to imminent danger that will lead to serious personal
injury or fatality.
WARNING
WARNING !
▶ Draws attention to a potential threat of danger that can lead to serious
injury or fatality.
CAUTION
CAUTION !
▶ Draws attention to a potentially dangerous situation that could lead to
personal injury or damage to the equipment or other property.
1.2.2 Symbols in the documentation
The following symbols are used in this document:
Read the operating instructions before use
Instructions for use and other useful information
Dealing with recyclable materials
Do not dispose of electric equipment and batteries as household
waste

Hilti TE 70-ATC Specifications

General

Single impact energy	11.5 J
Active Torque Control (ATC)	Yes
Vibration reduction	Yes
Drilling Diameter Range (Hammer Drill Bits)	12 - 40 mm
Chuck Type	TE-Y (SDS Max)
Dust Removal Module Available	Yes
Rated Voltage	230 V
Impact Energy	11.5 J
Power Output	900 W
Voltage	220-240 V
Frequency	50-60 Hz
Tool Holder	TE-Y (SDS Max)
Cord Length	4 m
Drilling Diameter Range (Core Bits)	40 - 150 mm
Working Mode	Hammer drilling, Drilling
Width	126 mm