HIMA HIMax X-HART 32 01 - Default Chapter; Table of Contents

X-HART 32 01 Table of Contents
HI 801 307 E Rev. 5.00 Page 3 of 58
Table of Contents
1
Introduction 5
1.1 Structure and Use of the Manual 5
1.2 Target Audience 5
1.3 Formatting Conventions 6
1.3.1 Safety Notes 6
1.3.2 Operating Tips 7
2 Safety 8
2.1 Intended Use 8
2.1.1 Environmental Requirements 8
2.1.2 ESD Protective Measures 8
2.2 Residual Risk 9
2.3 Safety Precautions 9
2.4 Emergency Information 9
3 Product Description 10
3.1 Safety Function 10
3.1.1 Reaction in the Event of a Fault 10
3.2 Scope of Delivery 10
3.3 Type Label 11
3.4 Structure 12
3.4.1 Block Diagram 12
3.4.2 Indicators 13
3.4.3 Module Status Indicators 14
3.4.4 System Bus Indicators 15
3.4.5 I/O indicators 15
3.5 Product Data 16
3.6 Connector Boards 18
3.6.1 Mechanical Coding of Connector Boards 18
3.6.2 Coding of X-CB 016 and X-CB 017 Connector Boards 19
3.6.3 Connector Boards for Analog Input Modules 20
3.6.4 Connector Board for Analog Output Modules 25
3.7 System cable 31
3.7.1 System Cable X-CA 005 31
3.7.2 Cable Plug Coding 31
3.7.3 System Cable X-CA 011 32
3.7.4 Cable Plug Coding 32
4 Start-up 33
4.1 Mounting 33
4.1.1 Wiring I/O Channels Not in Use 33
4.2 Mounting and Removing the Module 34
4.2.1 Mounting a Connector Board 34
4.2.2 Mounting and Removing the Module 36
4.3 Configuring the Module in SILworX 38
4.3.1 Tab: Module 39
4.3.2 Tab: I/O Submodule HART_32_01 40