HIMA HIMax X-HART 32 01 - Index of Tables

Appendix X-HART 32 01
Page 56 of 58 HI 801 307 E Rev. 5.00
Index of Tables
Table 1: Additional Valid Manuals 5
Table 2: Environmental Requirements 8
Table 3: Blinking Frequencies of LEDs 14
Table 4: Module Status Indicators 14
Table 5: System Bus Indicators 15
Table 6: I/O Indicators LEDs 15
Table 7: Product Data 16
Table 8: Specifications for the HART Channels 17
Table 9: Available Connector Boards 18
Table 10: Position of Coding Wedges on HART Module Slot 19
Table 11: Terminal Assignment for Connector Boards with Screw Terminals 22
Table 12: Cable Plug Properties 22
Table 13: Pin Assignment for the System Cable Plug 24
Table 14: Terminal Assignment for Mono Connector Boards with Screw Terminals 26
Table 15: Cable Plug Properties 26
Table 16: Terminal Assignment for Redundant Connector Boards with Screw Terminals 27
Table 17: Cable Plug Properties 27
Table 18: Pin Assignment for Mono Connector Boards with Cable Plug 29
Table 19: Pin Assignment for Redundant Connector Boards with Cable Plug 30
Table 20: Cable Data 31
Table 21: Available System Cables 31
Table 22: Cable Data 32
Table 23: Available System Cables 32
Table 24: Module Tab in the Hardware Editor 39
Table 25: Tab I/O Submodule HART_32_01 in the Hardware Editor 41
Table 26: Tab I/O Submodule HART_32_01:Channels in the Hardware Editor 42
Table 27: Submodule Status [DWORD] 42
Table 28: Diagnostic Information [DWORD] 43