Hioki 3169-20 - Basic Settings

Power Measurement
15
1
2
3
4
5
6
7
8
9
10
11
To initialize settings (p.17)
Basic Settings
See
1. Press the key to display the setting screen.
If the following screen is not displayed, press the SET UP key several times.
2. Set all items as shown on the screen below.
Move the cursor to the setting you wish to configure with the key and set it
with the to keys.
Instruction manual
"5.2 Setting on the
Measurement Set-
ting Screen (MEA-
SUREMENT)"
See
1
2
3
4
Two methods for performing 3-phase/3-wire power
measurement
• 3-phase/3-wire/2-meter (3P3W2M) method:
Power is calculated from two sets of voltage and current values (use for
normal measurement).
• 3-phase/3-wire/3-meter (3P3W3M) method:
Power is calculated from three sets of voltage and current values (use
when you wish to verify each phase’s power balance).
1