2.1 Voltage Measurement
Selecting the manual
range:
Reselecting the auto
range:
Press RANGE
("AUTO" is turned off)
Press RANGE
(for at least 1 sec-
ond) ("AUTO" lights up)
Holding the measured
value:
HOLD AUTO Function,
page 25) or
HOLD Function, page
26)
Press H.AUTO/REL
→ Measure-
ment
→ Intermittent sound →
Move the test leads away from the
measurement object.
Press H.AUTO/REL
+Power-on →
Measurement
→ Press H.AUTO/
REL
Appearance of O.F: The measured value exceeds 4200
counts (up to the 420-V range) or
1050 counts (1000-V range).
3. Connect the test leads t
the measurement objec
and read the indicate
value.
Black
Red
AC Voltage Measurement
Red
Black
DC Voltage Measurement
The indicated value may vary due to the existence
of induced voltage under no-power conditions.
However, this is not a problem.
To Next Page
Loading...
