viii
Attentions During Use
WARNING
The clamp sensor and voltage cord should be
connected to live lines after being connected to
the unit. To prevent short-circuiting and electric
shock, observe the following precautions:
Do not short-circuit the two wires of a line with
the clip of the voltage cord. Do not use the
clamp sensor on bare conductors.
To avoid electric shock when replacing the
battery, first disconnect the voltage cable or
clamp from the object to be measured. After
replacing the battery, always replace the cover
and tighten the screw before using the unit.
When replacing the battery, be sure to insert
them with the correct polarity. Otherwise, poor
performance or damage from battery leakage
could result. Replace battery only with the
specified type.
To avoid the possibility of explosion, do not
short circuit, disassemble or incinerate
batteries.
Handle and dispose of batteries in accordance
with local regulations.
To Next Page
Loading...
