vii
Attentions During Use
DANGER
To avoid short circuits and potentially life-
threatening hazards, never attach the clamp to a
circuit that operates at more than the maximum
rated voltage / 600V, or over bare conductors.
Clamp-on probe should only be connected to
the secondary side of a breaker, so the breaker
can prevent an accident if a short circuit occurs.
Connections should never be made to the
primary side of a breaker, because unrestricted
current flow could cause a serious accident if a
short circuit occurs.
WARNING
To avoid electric shock, do not allow the
product to get wet, and do not use it when your
hands are wet.
To avoid electric shock when measuring live
lines, wear appropriate protective gear, such as
insulated rubber gloves, boots and a safety
helmet.
Attentions During Use
Follow these precautions to ensure safe operation
and to obtain the full benefits of the various
functions.
To Next Page
Loading...
